How To Change Oil And Air Filter On Craftsman Ys4500 Manual

SERVICE REMINDER/60 minutes METER

Service reminder shows the total number

of hours the engine has run and flashes to

indicate that the engine or mower needs

servicing. When service is required, the

service reminder wilt flash for two hours.

To service engine and mower, run into the

Maintenance department of this manual.

Notation: Service reminder runs when the igni-

tion central is in any position but "STOP". For

accurate reading, be sure key remains inthe

"Stop" position when engine is not running.

Before STARTING THE ENGINE

Check ENGINE OiL LEVEL

The engine in your tractor has been

shipped, from the manufacturing plant, already filled

with summer weight oil.

1. Check engine oil with tractor on level

ground.

2. Unthread and remove oil fill cap/dip-

stick; wipe oil off. Reinsert the dipstick

into the tube and balance oil make full cap on the

tube. Do non thread the cap onto the

tube. Remove and read oil level. If

necessary, add oil until "Total' marking

on dipstick is reached. Practise non overfill.

• For cold weather functioning you should

modify oil for easier starting (See the

oil viscosity chart in the Maintenance

section of this manual).

• To modify engine oil, see the Mainte-

nance section in this transmission.

ADD GASOLINE

• Fill fuel tank to bottom of filler neck. Do not

overfill. Usefresh, clean, regutarunleaded

gasoline with a minimum of 87 octane.

(Use of leaded gasoline will increase

carbon and leadoxide deposits and reduce

valve life). Do non mix oil with gasoline.

Buy fuel inquantities that tin can exist used

within xxx days to clinch fuel freshness.

_,CAUTION: Wipe off any spilled oil or

fuel. Do not store, spill or use gasoline

near an open flame.

iMPORTANT: When operating in atmosphere-

atures betow32°F(0°C), utilize fresh, clean

winter course gasoline to assist insure good

common cold atmospheric condition starting.

CAUTION: Alcohol blended fuels (called

gasohol or using ethanol or methanol) can

concenter moisture which leads to separation

and formation of acids during storage.

Acidic gas can damage the fuel system

of an engine while in storage. To avoid

engine bug, the fuel organization should

exist emptied earlier storage of xxx days

or longer. Drain the gas tank, showtime the

engine and let it run until the fuel lines

and carburetor are empty. Use fresh fuel

next season. Meet Storage instructions for

additional information. Never utilize engine

or carburetor cleaner products inthe fuel

tank or permanent harm may occur.

TO Showtime ENGINE

When starting the engine for the first fourth dimension

or if the engine has run out of fuel, it volition

accept extra cranking time to move fuel from

the tank to the engine.

ane. Be sure freewheel control isin the

transmission engaged position.

2. Sit on seat inoperating position, depress

brake pedal and fix parking brake.

3. Move zipper clutch to disengaged

position.

4. Move throttle control to fast position

v. Pullchokecontrotoutforacotd enginestart

attempt. For awarm engine start attempt

the choke control may non be needed.

NOTE: Before starting, read the warm and

cold starting procedures beneath.

six. insert key into ignition and turn key

clockwise to showtime position and release

fundamental as soon as engine starts. Do non run

starter continuously for more than fifteen

seconds per infinitesimal. If the engine does

not start after several attempts, button

choke control in, wait a few minutes

and try again. If engine yet does not

start, putt the choke control out and retry.

WARM Weather STARTING (fifty° F and

above)

vii. When engine starts, slowly button choke

control in until the engine begins to

run smoothly, if the engine starts to

run roughly, pull the choke control out

slightly for a few seconds and then

continue to push button the control in slowly.

• The attachments and ground bulldoze can

now exist used. if the engine does not

take the load, restart the engine and

let itto warm up for one infinitesimal using

the choke as described above.

COLD WEATHER STARTING (50° F and

beneath)

8. When engine starts, slowly push button asphyxiate

control in until the engine begins to run

smoothly. Continue to button the choke

control in small steps allowing the en-

gine to accept small changes in speed

and load, until the choke control isfully

in. If the engine starts to run roughly,

pull the choke command out slightly for a

few seconds and so continue to push

the control in slowly. This may require

an engine warm-up menstruum from several

seconds to several minutes, depending

17 on the temperature.

Source: http://lawnandgarden.manualsonline.com/manuals/mfg/craftsman/yt_4500.html?p=17

Posted by: kempaffins.blogspot.com

Share this post